Phenolic insulation board construction method _ phenolic insulation board, phenolic board manufacturer
1, bottom-up from the beginning of the support part, with polymer glue cracking mortar, paste phenolic insulation board on the wall. Bonding area should be greater than 35%, the first layer is greater than 50%. Outer sheath heavier, per square meter to 4 - 6 bar.
2, adhesive for protective layer to stop 24 hours after the construction.
3, can be applied to every 24 hours the construction.
4, insulation board thickness, density according to the requirements of design, the general should not be less than 4 cm in the north of the Yellow River region, the density of 50 kg/m, cold area should be upset. Composite insulation decorative building insulation and decoration at an organic whole.
a, factory production. Phenolic insulation board will be solid adhesive on the decorative panel.
2, using light steel keel construction scheme, the composite insulation decorative hanging on keel, to be fixed.
3, a certain gap between plate handle to prevent leakage.
the transparent curtain wall can be adhesive in curtain wall panel or adhesion fixed in the wall. And forms a closed space between the curtain wall panel.
fire belt, according to the design requirements of spacing by the combined method of glue nail it may not be less than 30 cm.
special note: the new production of phenolic insulation board can be used to cure after 21 days commonly phenolic insulation board do not drop, do not soften at high temperature, low amount of smoke, no diffusion flame, flame penetration resistance, fire prevention performance is good, and it has good heat preservation and heat insulation effect, the excellent combination of fire resistance and good energy saving effect, is suitable for exterior insulation. http://www。 fenqbwb。 com